2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 325
DTC B0835
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B0835 00
- Cruise Control System Active Indicator Circuit
Diagnostic Fault Information
Circuit/System Description
The cruise control switch contains an LED that illuminates to indicate the cruise control system has been switched ON. Voltage is applied through
the ON/OFF switch to the LED when the switch is pressed. The body control module (BCM) provides the ground path for the LED through a
dedicated LED control circuit. Pressing the switch again opens the switch and the lamp turns OFF.
Conditions for Running the DTC
* The ignition is ON.
* The cruise switch is ON.
Conditions for Setting the DTC
* The BCM detects excessive current in the cruise control indicator signal circuit.
* The above condition is present for greater than 5 seconds.
Actions Taken When the DTC Sets
* The malfunction indicator lamp (MIL) will not illuminate.
* The cruise control system is disabled.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear after 40 malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Cruise Control Schematics (See: Cruise Control/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Cruise Control Description and Operation (See: Cruise Control/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
