2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 342
Circuit/System Description
The parking assist system can be disabled by pressing the parking assist disable switch. When the parking assist system is disabled the object alarm
module will ground the parking assist disable indicator control circuit, illuminating the indicator.
Conditions for Running the DTC
* DTC B1325 is not set
* Ignition voltage is between 9-16 volts
Conditions for Setting the DTC
The object alarm module detects the parking assist disable indicator control circuit is shorted to ground, shorted to voltage or open.
Action Taken When the DTC Sets
* The parking assist system is disabled.
* The object alarm module sends a serial data message to the instrument panel cluster (IPC) to display SERVICE PARK ASSIST message in
the driver information center (DIC).
Conditions for Clearing
* The DTC will transition to history when the fault is no longer present.
* A history DTC will clear after 100 malfunction-free ignition cycles.
Reference Information
Schematic Reference
Object Detection Schematics (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Diagrams/Electrical
Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Object Detection Description and Operation (UFT) (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Description and Operation/Object Detection Description and Operation (UFT))Object Detection Description and Operation (UVC) (See:
Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Description and Operation/Object Detection Description and
Operation (UVC))Object Detection Description and Operation (UD7) (See: Accessories and Optional Equipment/Collision Avoidance and
Parking Assist Systems/Description and Operation/Object Detection Description and Operation (UD7))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool Park Assist Switch LED parameter while pressing and releasing the park assist disable switch. The parameter
should change between On and Off.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the I/P multifunction switch.
2. Ignition ON, verify a test lamp illuminates between the appropriate ignition circuit listed below and ground:
* RPO X88/Z88 ignition circuit terminal 6
* RPO Z75 ignition circuit terminal 4
瀚慖f the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
