2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 299
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Circuit/System Verification
1. Ignition ON, doors unlocked, transaxle in Park, enable the power liftgate by pressing the liftgate enable/disable button on the I/P switch
assembly.
2. Open the liftgate by pressing the touchpad on the liftgate handle switch. The liftgate should release and power open.
3. Close the liftgate by pressing the liftgate button switch. The liftgate should power close, cinch-in, and latch.
Circuit/System Testing
1. Ignition OFF, disconnect the X3 harness connector at the K39 liftgate control module.
2. Test for less than 15 ohm between the control terminal 14 at the K39 liftgate control module and ground.
瀚慖f greater than the specified range, replace the K39 liftgate control module.
3. Test for less than 15 ohm between the control terminal 13 at the K39 liftgate control module and ground.
瀚慖f greater than the specified range, replace the K39 liftgate control module.
4. Test for 9-10 ohm between the control circuit terminal 13 and control circuit terminal 14 at the liftgate motor assembly.
瀚慖f less than the specified range, test either control circuit for a short to ground. If the circuits test normal, replace the M17 liftgate motor
assembly.
瀚慖f greater than the specified range, test either control circuit for a short to voltage or an open/high resistance. If the circuits test normal,
replace the M17 liftgate motor assembly.
5. If all circuits test normal, replace the M17 liftgate motor assembly.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Liftgate Close Actuator Motor Replacement (See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Motor/Service
and Repair/Liftgate Close Actuator Motor Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning)for liftgate control module replacement,
programming, and setup
B396F
DTC B396F
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B396F 06
- Liftglass Ajar Output Signal Circuit Short to Ground or Open
DTC B396F 0B
- Liftglass Ajar Output Signal Circuit Current Above Threshold
Diagnostic Fault Information
