Saturday, November 9, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 120

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 120

Diagnostic Aids

* When a harness connector is disconnected, the high control and low control circuits are shorted together by the integral shorting bar. This

should be taken into account when testing for faults on these circuits.

* This DTC usually indicates a poor connection or a wiring malfunction between the SDM and the deployment loop.

Reference Information

Schematic Reference

SIR Schematics (See: Diagrams/Electrical Diagrams/Air Bag Systems)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

SIR System Description and Operation (See: Restraints and Safety Systems/Air Bag Systems/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Special Tools Required

J 38715-A Driver and Passenger SIR Load Tool

Circuit/System Verification

Note: Refer to SIR Service Precautions (See: Restraints and Safety Systems/Air Bag Systems/Service Precautions/Technician Safety Information)

Inspect all terminals for damage or corrosion when disconnecting connectors. Damage or corrosion in the following requires repair or replacement

of the affected component/connector.

* Seat belt pretensioner

* Passenger instrument panel airbag

* Side air bag

* Roof rail airbag

* SDM

* SDM wiring harness connector

Note: The connector and connector position assurance (CPA) may seat independent of each other. Both the connector and CPA should seat with an

audible and/or tactile click. The CPA isolates the shorting-bars within the connector allowing the deployment circuit to operate properly.

If the condition is intermittent or cannot be duplicated, disconnect the connectors and add Nyogel lubricant 760G. This procedure will correct the

high resistance condition due to terminal fretting corrosion.

Observe the scan tool Deployment Loop Resistance parameters while moving the harness near each connector listed below. The reading should stay

consistently between 1.7 and 4.2 ohm without any drop outs or spikes.

* Passenger instrument panel air bag

* Roof rail air bag

* Seat side air bag

* Seat belt pretensioner

* Any inline harness

* SDM

If the reading is erratic while moving the harness, perform the following;

* Inspect each connector terminal for damage or corrosion and repair as necessary.

* Apply Nyogel lubricant 760G to each connector terminal.

* Insure each connector and CPA is correctly seated.