Monday, December 9, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 774

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 774

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Brake Pressure Modulator Valve Replacement (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic

Control Assembly - Antilock Brakes/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, programming and setup

C12BB

DTC C012C, C121A, C128C, C128F, C12B9, C12BA, C12BB, or C12F7

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C12F7

- ABS Boost Pressure Sensor and Regenerative Axle Pressure Sensor Not Plausible

DTC C128F

- ABS Regenerative Axle Pressure Sensor Raw Offset Error

DTC C012C 01

- Regenerative Axle Pressure Sensor Short to Battery

DTC C12BA

- ABS Regenerative Axle Pressure Sensor Circuit Short To Battery

DTC C012C 06

- Regenerative Axle Pressure Sensor Short to Ground or Open

DTC C12B9

- ABS Regenerative Axle Pressure Sensor Circuit Open or Short To Ground

DTC C012C 11

- Regenerative Axle Pressure Sensor Above Maximum Threshold

DTC C128C

- ABS Regenerative Axle Pressure Sensor Offset Error

DTC C012C 0F

- Regenerative Axle Pressure Sensor Erratic

DTC C12BB

- ABS Regenerative Axle Pressure Sensor Erratic

DTC C121A

- ABS Regenerative Axle Pressure Sensor

Circuit/System Description

The electronic brake control module (EBCM) uses input from the regenerative axle pressure sensor for more accurate control during a brake and

vehicle stability enhancement system (VSES) event. The regenerative axle pressure sensor is internal to the brake pressure modulator valve

assembly.

Conditions for Running the DTC

* Ignition ON.

* Ignition voltage is greater than 10 volts.

Conditions for Setting the DTC