Thursday, December 5, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 685

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 685

Release Systems Schematics (See: Body and Frame/Locks/Diagrams/Electrical Diagrams/Release Systems Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Liftgate Description and Operation (See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, command the liftglass latch to release the liftglass by pressing the liftgate window release switch. The liftglass latch should release the

liftglass.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the rear window wiper motor.

2. Ignition ON, connect a test lamp between the signal circuit terminal B and ground.

3. Command the liftglass latch to release by pressing the liftgate window release switch. The test lamp should briefly illuminate when the

liftgate window release switch is pressed.

瀚慖f the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the BCM.

瀚慖f the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.

4. If all circuits test normal, replace the rear window wiper motor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Rear Window Wiper Motor Replacement (See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Rear Window Wiper Motor

Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement and setup procedures

B3445

DTC B3445

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B3445 00

- Stop Lamp Circuit

Diagnostic Fault Information