2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 345

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 345

The module refuses all additional inputs.

Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.

* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 100, without a repeat of the malfunction.

Diagnostic Aids

* This DTC may be stored as a history DTC without affecting the operation of the control module.

* Do not replace a control module based only on DTC B1000 being set in history with the exception of the following control modules:

- Sensing and Diagnostic Module (SDM)

- Rollover Sensor

- Passenger Presence System Module

* If DTC B1000 is set as current, replace the appropriate control module.

Circuit/System Verification

If the DTC is set, replace the appropriate control module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.

Control Module References (See: Testing and Inspection/Programming and Relearning) for module replacement, setup, and programming

Data Communications

DTC B1001

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B1001 00

- Option Configuration Error

DTC B1001 45

- Option Configuration Error Variant Not Programmed

DTC B1001 46

- Option Configuration Error

DTC B1001 4B

- Option Configuration Error Calibration Not Learned

Circuit/System Description

Some control modules must be configured with serial numbers, vehicle options, or other information. If a control module was not properly

configured after installation, that module may set DTC B1001.

Conditions for Running the DTC

Battery voltage is between 9-16 volts and data link communications operate normally.

Conditions for Setting the DTC

The control module is not configured properly.