Showing posts with label Verify that DTC C005A is not set.. Show all posts
Showing posts with label Verify that DTC C005A is not set.. Show all posts

Monday, December 9, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 764

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 764

Verify that DTC C005A is not set.

If the DTC is set, refer to DTC C0035-C0050, C1207-C1210, C1221-C1228, or C1232-C1235 ( See: C Code Charts/C0035)

C012A

DTC C012A, C128B, C128E, or C12B2-C12B4

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C012A 00

- Master Cylinder Pressure Sensor

DTC C128E

- Master Cylinder Pressure Sensor

DTC C012A 01

- Master Cylinder Pressure Sensor Short to Battery

DTC C12B3

- Master Cylinder Pressure Sensor Short to Battery

DTC C012A 06

- Master Cylinder Pressure Sensor Short to Ground or Open

DTC C12B2

- Master Cylinder Pressure Sensor Short to Ground or Open

DTC C012A 11

- Master Cylinder Pressure Sensor Above Maximum Threshold

DTC C128B

- Master Cylinder Pressure Sensor Above Maximum Threshold

DTC C012A 0F

- Master Cylinder Pressure Sensor Erratic

DTC C12B4

- Master Cylinder Pressure Sensor Erratic

Circuit/System Description

The electronic brake control module (EBCM) uses input from the master cylinder pressure sensor for more accurate control during a vehicle

stability enhancement system event. The master cylinder pressure sensor is internal to the brake pressure modulator valve.

Conditions for Running the DTC

* The ignition is ON.

* Ignition voltage is greater than 10 volts.

* The brake pedal is not applied.

Conditions for Setting the DTC

C012A 00, C128E or C128B

Internal sensor failure is detected.