Showing posts with label disconnect the harness connector at the EBCM.. Show all posts
Showing posts with label disconnect the harness connector at the EBCM.. Show all posts

Thursday, December 19, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 993

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 993

1. Ignition OFF, disconnect the harness connector at the EBCM.

2. Test for less than 1 ohm between the ground circuits listed below and ground.

* Terminal 13

* Terminal 38

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground.

* Terminal 1

* Terminal 25

瀚慖f the test lamp does not illuminate, test the appropriate circuit for a short to ground or an open/high resistance.

4. If all circuits test normal, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming

C123D

DTC C056D, C120C, C121C, C121E, C121F, C123A-C1256, C126E-C127C, C12C2-C12DB, C12DE, C12DF, or C12F2-C12F6

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provide an overview of each diagnostic category.

DTC Descriptors

DTC C056D 00

- ECU Hardware Performance

DTC C056D 3C

- ECU Hardware Performance Internal Communications Failure

DTC C056D 59

- ECU Hardware Performance

DTC C120C

- Brake Pedal Position Sensor 4 Plausibility

DTC C121C

- EBCM Internal Communication Error

DTC C121E

- EBCM Unimplemented Interrupt

DTC C121F

- EBCM Unexpected Exception

DTC C123A

- EBCM High End Timer Watchdog

DTC C123B

- EBCM High End Timer Program Overflow

DTC C123C

- EBCM High End Timer RAM Fault