2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 759
- Evaporator Air Temperature Sensor Short to Ground
DTC B3933 05
- Evaporator Air Temperature Sensor Short to Battery or Open
Circuit Description
The HVAC control module supplies the evaporator air temperature sensor with a low reference circuit and 5-volt signal circuit. The HVAC control
module determines the voltage drop across the sensor, which is proportional to temperature. As the air temperature increases, the sensor resistance
decreases and the voltage signal decreases. As the air temperature decreases, the sensor resistance increases and the voltage signal increases.
Conditions for Running the DTC
The ignition is turned ON.
Conditions for Setting the DTC
The HVAC control module detects the evaporator air temperature sensor signal circuit is less than -36掳C (-38掳F) or more than 215掳C (419掳F) for
more than 15 seconds.
Action Taken When the DTC Sets
The A/C compressor will be disabled.
Conditions for Clearing the DTC
* The DTC will become history if the HVAC control module no longer detects a failure.
* The history DTC will clear after 100 fault-free ignition cycles.
Reference Information
Schematic Reference
HVAC Schematics (See: Heating and Air Conditioning/Diagrams/Electrical Diagrams/HVAC - Manual)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
* Air Delivery Description and Operation (See: Heating and Air Conditioning/Description and Operation/HVAC - Manual/Air Delivery
Description and Operation)
* Air Temperature Description and Operation (See: Heating and Air Conditioning/Description and Operation/HVAC - Manual/Air
Temperature Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool A/C Evaporator Temperature Sensor parameter. The reading should be between -39掳F (-35掳C) and 208掳F (98掳C)
and change with evaporator air temperature changes.
Circuit/System Testing
Note: If the evaporator air temperature sensor has an out of range condition caused by a short to voltage, short to ground, or an open/high
resistance, the scan tool will display the same value: 11掳C (51掳F).
1. Ignition OFF, disconnect the harness connector at the evaporator air temperature sensor.
2. Ignition OFF, test for less than 10 ohms between the low reference circuit terminal 2 and ground.
